Home › Service Areas › Basingstoke • Boiler Repair
Embassy Gas • Basingstoke (RG21–RG24)

Boiler Repair in Basingstoke

Boiler repairs across Basingstoke for no heating, no hot water, leaks, pressure drops and fault codes. Proper diagnostics, clear options, and repairs that stop repeat breakdowns — no nonsense, no upselling.

Book a Boiler Repair Boiler Service Breakdown Cover Boiler Installation
Common Faults Basingstoke Repair Issues What Happens on Visit FAQs
Gas Safe Engineers Proper Diagnostics Clear Repair Options RG Postcodes

Basingstoke-specific repair focus

Across RG21–RG24, we see a mix of newer estates and older pockets, often with combi boilers and higher hot-water demand. In areas like Kempshott, Chineham, Brighton Hill, Hatch Warren, South Ham and the town centre, common repair drivers include pressure loss, diverter faults, sensor issues, and sludge-related circulation problems.

Our focus is simple: identify the root cause, repair properly, and advise on prevention (service timing, inhibitor, and filtration).

Common in Basingstoke
Intermittent hot water, pressure drops, noisy pumps, flow/temperature sensor faults, condensate issues.
Homes we regularly see
Modern family homes, flats near the centre, and mixed-age housing across RG21–RG24.

Before you book (safe quick checks)

No heating / no hot water
Check programmer + thermostat demand. Note fault codes and when the fault occurs.
Low pressure
Below ~1 bar can cause lockouts. Repressurise only if you’re confident and it’s safe.
Frozen condensate
If the condensate pipe runs outside, cold snaps can freeze it and stop the boiler firing.
Leak / water near boiler
Turn the boiler off and book in — water can damage electronics and components quickly.

Common boiler faults we repair in Basingstoke

We repair combi, system and regular boilers. After diagnosis, we explain what failed, why it failed, and the best route forward.

Pressure faults
PRV discharge, expansion vessel issues, leaks on valves/pipework, worn seals.
Hot water issues (combi)
Diverter valve faults, scaled plate heat exchanger, flow/temperature sensors.
Ignition / lockouts
Ignition components, flame sensing, fan/APS issues, control/PCB-related faults.
Noisy boiler / kettling
Restricted flow, scale/sludge build-up, pump problems, trapped air.

What happens on a repair visit

Diagnose first, confirm options, then fix. If repair isn’t sensible, we’ll tell you and help you plan replacement on your terms.

1) Diagnosis first
Root cause checks plus key safety/combustion-related observations.
2) Clear options
You get a straight explanation: what failed, likely causes, and best fix.
3) Repair & test
Where viable we repair on-site, then test operation and confirm stability.
4) Prevention advice
Service cadence, inhibitor/filters, and what to watch for going forward.
Boiler Repair in Basingstoke – FAQs
Can you fix no heating / no hot water?
Yes — we diagnose then repair where viable. Fault codes help speed up diagnosis.
Why does my boiler keep losing pressure?
Usually a leak, PRV/expansion vessel fault, or worn internal seals. We’ll pinpoint the cause.
Do you repair all boiler types?
Yes — combi, system and regular boilers across Basingstoke and RG21–RG24.
Should I repair or replace?
If repairs are frequent or the boiler is older, replacement can be better value. We’ll advise honestly.
Book Repair Cover
Link copied

Embassy Gas

You’re connected to Ember
– your AI assistant for today

🟢 Ember is online

Ember is typing…